HP인증사에서 주췌하는 HP0-207시험은 IT업계에 종사하는 분이시라면 모두 패스하여 자격증을 취득하고 싶으리라 믿습니다. ITExamDump에서는 여러분이 IT인증자격증을 편하게 취득할수 있게 도와드리는 IT자격증시험대비시험자료를 제공해드리는 전문 사이트입니다. ITExamDump덤프로 자격증취득의 꿈을 이루세요.
아직도 HP인증HP0-207시험준비를 어떻게 해야 할지 망설이고 계시나요? 고객님의 IT인증시험준비길에는 언제나 ITExamDump가 곁을 지켜주고 있습니다. ITExamDump시험공부자료를 선택하시면 자격증취득의 소원이 이루어집니다. HP인증HP0-207시험덤프는ITExamDump가 최고의 선택입니다.
ITExamDump에서는 전문HP HP0-207인증시험을 겨냥한 덤프 즉 문제와 답을 제공합니다.여러분이 처음HP HP0-207인증시험준비라면 아주 좋은 덤프입니다. ITExamDump에서 제공되는 덤프는 모두 실제시험과 아주 유사한 덤프들입니다.HP HP0-207인증시험패스는 보장합니다. 만약 떨어지셨다면 우리는 덤프비용전액을 환불해드립니다.
여러분은 먼저 우리 ITExamDump사이트에서 제공되는HP인증HP0-207시험덤프의 일부분인 데모를 다운받으셔서 체험해보세요. ITExamDump는 여러분이 한번에HP인증HP0-207시험을 패스하도록 하겠습니다. 만약HP인증HP0-207시험에서 떨어지셨다고 하면 우리는 덤프비용전액 환불입니다.
시험 번호/코드: HP0-207
시험 이름: HP (Procurve Adaptive EDGE Fundamentals)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 120 문항
업데이트: 2013-10-31
IT업계에 종사하고 계시나요? 최근 유행하는HP인증 HP0-207 IT인증시험에 도전해볼 생각은 없으신지요? IT 인증자격증 취득 의향이 있으시면 저희. ITExamDump의 HP인증 HP0-207덤프로 시험을 준비하시면 100%시험통과 가능합니다. ITExamDump의 HP인증 HP0-207덤프는 착한 가격에 고품질을 지닌 최고,최신의 버전입니다. ITExamDump덤프로 가볼가요?
HP0-207 덤프무료샘플다운로드하기: http://www.itexamdump.com/HP0-207.html
NO.1 You must update the software on a customer's ProCurve Switch 5412zl. Which statement
correctly describes the process for this operation? Select TWO.
A.Use TFTP for direct serial transfer of the software.
B.Use FTP for in-band transfer of the software through an IP network.
C.Use TFTP for in-band transfer of the software through an IP network.
D.Transfer the software from your workstation using a direct serial transfer.
E.Instruct the switch to search for any available TFTP server without knowing its IP address.
Correct:C D
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.2 What are the primary solution categories of the Adaptive EDGE Architecture? Select THREE.
A.mobility
B.security
C.reliability
D.availability
E.upgradeability
F.convergence
G.cost-effectiveness
Correct:A B F
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.3 While examining the spanning tree configuration on a ProCurve switch, you notice that one of
the ports is in the Blocking state. Which statement describes how this port will function in this
state?
A.The port is completely blocked for all purposes.
B.The switch will not forward user traffic through that port, but will forward telnet traffic.
C.The switch will not forward user traffic through that port, but will forward BPDUs through that port.
D.The switch forwards user traffic through that port, but does not receive user traffic through that port.
Correct:C
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.4 How is traffic prioritization accomplished with IEEE 802.1p?
A.802.1Q-compliant devices enforce priorities based on VLAN ID.
B.802.1Q-compliant devices set one of 8 values in a 3-bit field in the VLAN tag.
C.802.1Q-compliant devices set one of 64 values in a 6-bit field in the IP datagram header.
D.802.1Q-compliant devices dedicate a portion of available bandwidth to each prioritized conversation.
Correct:B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.5 On switches that support the Switch Setup screen interface, which parameters can be
configured on the Switch Setup screen? Select TWO.
A.STP bridge priority
B.IP address of the TACACS+ server
C.system name and contact information
D.IP address and subnet mask for each VLAN
E.IP address and subnet mask for the default VLAN
Correct:C E
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.6 You are about to update the software on a ProCurve switch. Which command do you use to view
a list of all software versions stored on the switch?
A.show run
B.show flash
C.show startup
D.show version
Correct:B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.7 At a customer site, you have configured four ProCurve switches for HP Switch Meshing and
Multiple Spanning Tree Protocol. How will the mesh appear to non-mesh switches in the same
spanning tree domain?
A.as a single device
B.as a set of devices without redundant links
C.as devices that cannot participate in the spanning tree
D.as a set of devices with spanning tree enabled to block redundant links
Correct:A
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.8 A customer is planning a Power over Ethernet deployment for a large call center that will use
VoIP telephones. While planning the wiring closets for the deployment, the customer suggests
using the uplink ports of a ProCurve Switch 2650-PWR to provide power to a ProCurve Switch
2600-8-PWR. Which statement describes a correct response to this suggestion?
A.It is only possible if the second switch is a ProCurve Switch 2626-PWR.
B.It is not possible because the 2600-8-PWR cannot act as a Powered Device.
C.It is only possible if the customer adds a ProCurve 600 EPS/RPS to the first switch.
D.It is not recommended because the second switch will not have adequate power redundancy.
Correct:B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.9 While using the CLI to configure a ProCurve switch, you must change context from the manager
level to the global configuration level. Which command do you use?
A.exit
B.write
C.global
D.enable
E.configure
Correct:E
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.10 You are implementing a fully connected HP Switch Mesh at a customer site. Which statement
describes a valid design guideline for HP Switch Meshing?
A.A switch may be connected to no more than four mesh domains.
B.Up to five Switch 5400zl Series switches can be included in a full mesh.
C.All links in a full mesh must operate at the same speed and use the same media type.
D.When a switch is configured for HP Switch Meshing protocol, all of the ports on that switch must
participate in the mesh.
Correct:B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.11 You are installing a ProCurve switch at a customer site and must enable remote management
for network administrators. Which configuration parameter is necessary to ensure that
administrators can manage the switch even if they are on different IP networks?
A.default VLAN
B.default gateway
C.default password
D.default management profile
Correct:B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.12 You are configuring a ProCurve Layer 2 switch to obtain time information from an SNTP server
located on a different IP network than the switch. Which configuration steps are necessary on the
switch to enable this functionality?
A.The switch cannot be configured to obtain time information from a server on a different IP network.
B.Define a default gateway for the switch, enable SNTP, use the sntp server command to enter the IP
address of the server.
C.Assign a port on the switch to a VLAN that includes the SNTP server, enable SNTP, configure the
switch for SNTP unicast mode.
D.Configure an IP address on the same IP network as the SNTP server, enable TimeP, configure the
switch for SNTP broadcast mode.
Correct:B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.13 You must remotely manage a customer's switch using Telnet. Which configuration/monitoring
interfaces are available? Select TWO.
A.web interface
B.menu interface
C.ProCurve Manager
D.boot monitor interface
E.command line interface
Correct:B E
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.14 You have been asked to configure IGMP on a ProCurve Switch 6200yl at a customer site. What
are the steps for enabling IGMP on the switch?
A.Enter the manager level, then issue the ip igmp command.
B.Enter the global configuration context, then issue the ip igmp command.
C.Enter the VLAN context for each VLAN that will support IGMP, then issue the ip igmp command.
D.Enter the interface configuration context for each port configured with a VLAN, then issue the ip igmp
command.
Correct:C
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.15 You configured Rapid Spanning Tree Protocol on four ProCurve Switch 5348xl switches at a
customer site. During the configuration, you forgot to configure the switches so that
switch-to-switch links are not defined as edge ports. Which statement describes the consequence
of your oversight?
A.The switches in the spanning tree will elect multiple Root bridges.
B.The switches will reject the spanning tree configuration and block all ports until the configuration is
corrected.
C.The switches will be unable to elect a Root bridge and will not be able to forward traffic until the
configuration is corrected.
D.The switches will require more time to elect the Root bridge and resolve the topology, but the spanning
tree will otherwise function normally.
Correct:D
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.16 You are about to configure HP Switch Meshing on four ProCurve switches at a customer site.
All of the ports that will be included in the mesh are configured for membership in customer
VLANs. How will the mesh configuration affect the VLAN configuration?
A.The mesh ports will automatically become a tagged member of all configured VLANs.
B.The mesh ports will not be a member of any VLANs until you manually configure its VLAN assignments.
C.The mesh ports will not be 802.1Q-compliant and will only be able to retain membership in a single
untagged VLAN.
D.The mesh ports will automatically become a member of the default VLAN and must be configured for
other VLAN membership.
Correct:A
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.17 You are assigned to configure ProCurve switches at a customer site for in-band management.
Which are in-band management methods? Select TWO.
A.Telnet
B.SNMP
C.XMODEM
D.serial console
E.menu interface
Correct:A B
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.18 What are the key principles of the Adaptive EDGE architecture? Select TWO.
A.Control to the Edge
B.Control to the Desktop
C.Command from the Center
D.Management from Anywhere
E.Security throughout the Network
Correct:A C
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.19 While using the CLI to configure a ProCurve switch, you must move from the global
configuration level to the port context configuration level for port a1. Which command do you use?
A.port a1
B.ethernet a1
C.interface a1
D.configure a1
Correct:C
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
NO.20 How do ProCurve switches, configured with link aggregation (also known as port trunking),
handle broadcast traffic?
A.Broadcast traffic is flooded through all of the ports in the trunk.
B.The switch sends a query and receives permission from potential receivers before flooding.
C.Broadcast traffic is handled in exactly the same way it would be without port trunking configured.
D.Broadcast traffic is flooded through non-trunked ports, but forwarded only through one of the ports in
the trunk.
Correct:D
HP덤프 HP0-207자격증 HP0-207 HP0-207 dumps
ITexamdump의 MB5-700덤프의 VCE테스트프로그램과 000-318덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 HP0-Y46시험에 대비한 고품질 덤프와 70-332시험 최신버전덤프를 제공해드립니다. 최고품질 700-104시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기