우리ITExamDump 는 많은IT전문가들로 구성되었습니다. 우리의 문제와 답들은 모두 엘리트한 전문가들이 만들어낸 만큼 시험문제의 적중률은 아주 높습니다. 거이 100%의 정확도를 자랑하고 있습니다. 아마 많은 유사한 사이트들도 많습니다. 이러한 사이트에서 학습가이드와 온라인서비스도 지원되고 있습니다만 우리ITExamDump는 이미 이러한 사이트를 뛰어넘은 실력으로 업계에서는 우리만의 이미지를 지키고 있습니다. 우리는 정확한 문제와답만 제공하고 또한 그 어느 사이트보다도 빠른 업데이트로 여러분의 인증시험을 안전하게 패스하도록합니다.Cisco 642-883인증시험을 응시하려는 분들은 저희 문제와 답으로 안심하시고 자신 있게 응시하시면 됩니다. 우리ITExamDump 는 여러분이 100%Cisco 642-883인증시험을 패스할 수 있다는 것을 보장합니다.
ITExamDump 의 Cisco인증 642-883덤프는Cisco인증 642-883시험에 도전장을 던진 분들이 신뢰할수 있는 든든한 길잡이 입니다. Cisco인증 642-883시험대비 덤프뿐만아니라 다른 IT인증시험에 대비한 덤프자료도 적중율이 끝내줍니다. Cisco인증 642-883시험이나 다른 IT인증자격증시험이나ITExamDump제품을 사용해보세요.투자한 덤프비용보다 훨씬 큰 이득을 보실수 있을것입니다.
시험 번호/코드: 642-883
시험 이름: Cisco (Deploying Cisco Service Provider Network Routing (SPROUTE) )
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 82 문항
업데이트: 2014-01-17
여러분은Cisco 642-883인증시험을 패스함으로 IT업계관련 직업을 찿고자하는 분들에게는 아주 큰 가산점이 될수 있으며, 성덩한 IT업계사업자와 한걸음 가까와 집니다.
ITExamDump의 Cisco인증 642-883시험덤프는 실제시험의 기출문제와 예상문제를 묶어둔 공부자료로서 시험문제커버율이 상당히 높습니다.IT업계에 계속 종사하려는 IT인사들은 부단히 유력한 자격증을 취득하고 자신의 자리를 보존해야 합니다. ITExamDump의 Cisco인증 642-883시험덤프로 어려운 Cisco인증 642-883시험을 쉽게 패스해보세요. IT자격증 취득이 여느때보다 여느일보다 쉬워져 자격증을 많이 따는 꿈을 실현해드립니다.
ITExamDump의 Cisco인증 642-883덤프로 시험공부를 하신다면 고객님의 시간은 물론이고 거금을 들여 학원등록하지 않아도 되기에 금전상에서도 많은 절약을 해드리게 됩니다. Cisco인증 642-883덤프 구매의향이 있으시면 무료샘플을 우선 체험해보세요.
642-883 덤프무료샘플다운로드하기: http://www.itexamdump.com/642-883.html
NO.1 When troubleshooting OSPF neighbor errors, which three verification steps should be considered.?
(Choose three.)
A. Verify if neighboring OSPF interfaces are configured in the same area.
B. Verify if neighboring OSPF interfaces are configured with the same OSPF process ID.
C. Verify if neighboring OSPF interfaces are configured with the same OSPF priority.
D. Verify if neighboring OSPF interfaces are configured with the same hello and dead intervals.
E. Verify if neighboring OSPF interfaces are configured with the same area type.
Answer: A,D,E
Cisco 642-883 642-883 642-883 642-883 dumps
NO.2 In comparing IS-IS with OSPF, a Level-1-2 IS-IS router is similar to which kind of OSPF router?
A. ASBR on a normal OSPF area
B. ASBR on NSSA
C. ABR on totally stubby OSPF area
D. ABR on stubby OSPF area
E. ABR on a normal OSPF area
Answer: C
Cisco 642-883 642-883 642-883자격증
NO.3 Refer to the OSPF command exhibit.
Which effect does the no-summary command option have?
A. It will cause area 1 to be able to receive non-summarized inter-area routes.
B. It will cause area 1 to not receive any inter-area routes and will use a default route to reach networks in
other areas.
C. It will cause area 1 to not receive any external routes and will use a default route to reach the external
networks.
D. It will convert the NSSA area into a NSSA totally stubby area.
E. It will convert the stubby area into a NSSA.
F. It will disable OSPF auto-summary.
Answer: B
Cisco 642-883인증 642-883 dump 642-883자격증 642-883덤프 642-883
NO.4 On Cisco IOS XR Software, which set of commands is used to enable the gi0/0/0/1 interface for OSPF
in area 0?
A. interface gi0/0/0/0 ip address 10.1.1.1 255.255.255.0 ! router ospf 1 network 10.1.1.1 0.0.0.0 area 0
B. interface gi0/0/0/0 ip address 10.1.1.1 255.255.255.0 ! router ospf 1 network 10.1.1.1 255.255.255.255
area 0
C. router ospf 1 area 0 interface GigabitEthernet0/0/0/1
D. interface gi0/0/0/0 ip address 10.1.1.1 255.255.255.0 ip ospf 1 area 0
E. router ospf 1 address-family ipv4 unicast interface GigabitEthernet0/0/0/1 area 0
F. router ospf 1 address-family ipv4 unicast interface GigabitEthernet0/0/0/1 area 0
Answer: C
Cisco 642-883 dumps 642-883
NO.5 Which four statements are correct regarding IS-IS operations? (Choose four.)
A. By default, Level 1 routers within an IS-IS area do not carry any routing information external to the area
to which they belong. They use a default route to exit the area.
B. Summarization should be configured on the Level 2 routers, which injects the Level 2 routes into Level
1.
C. IS-IS supports "route leaking" in which selected Level 2 routes can be advertised by a Level 1/Level 2
router into Level 1.
D. The IS-IS backbone is a contiguous collection of Level 1 capable routers, each of which can be in a
different area.
E. With IS-IS, an individual router is in only one area, and the border between areas is on the link that
connects two routers that are in different areas.
F. Cisco IOS XR Software supports multitopology for IPv6 IS-IS unless single topology is explicitly
configured in IPv6 address-family configuration mode.
Answer: A,C,E,F
Cisco 642-883 642-883 642-883 pdf
NO.6 When configuring IPv4 and IPv6 IS-IS routing on Cisco IOS XR routers, which three statements are
correct? (Choose three.)
A. By default, a single SPF is used for both IPv4 and IPv6, so the IPv4 and IPv6 topology should be the
same.
B. By default, the IS-IS router type is Level 1 and Level 2.
C. All IS-IS routers within the same IS-IS area must be configured with the same IS-IS routing process
instance ID.
D. By default, metric-style narrow is used.
E. By default, the IS-IS interface circuit type is Level 1 and Level 2.
F. The area IS-IS address-family configuration command is used to specify the IS-IS area address.
Answer: B,D,E
Cisco 642-883자격증 642-883 dump 642-883자격증
NO.7 Refer to the PE1 router routing table output exhibit.
What is causing the i su 10.1.10.0/24 [115/30] via 0.0.0.0, 00:40:34, Null0 entry on the PE1 router routing
table?
A. The PE1 router is receiving the 10.1.10.0/24 summary route from the upstream L1/L2 IS-IS router.
B. The PE1 router has been configured to summarize the 10.1.10.x/32 IS-IS routes to 10.1.10.0/24.
C. The 10.1.10.0/24 has been suppressed because IS-IS auto-summary has been disabled on the PE1
router.
D. The 10.1.10.0/24 has been suppressed because of a route policy configuration on the PE1 router.
E. The 10.1.10.0/24 has been suppressed because the more specific 10.1.10.x/32 IS-IS routes have
been configured to leak into the IS-IS non-backbone area.
Answer: B
Cisco 642-883인증 642-883
NO.8 What is function of the RP/0/RSP0/CPU0:PE1(config-ospf)#distance Cisco IOS-XR command?
A. To modify the administrative distance of the OSPF routes
B. To modify the default seed metric of the OSPF external routes
C. To modify the OSPF default reference bandwidth
D. To modify the OSPF cost
Answer: A
Cisco 642-883시험문제 642-883 642-883 642-883자격증 642-883기출문제
NO.9 Which two OSPF network scenarios require OSPF virtual link configuration? (Choose two.)
A. to connect an OSPF non-backbone area to area 0 through another non-backbone area
B. to connect an NSSA area to an external routing domain
C. to connect two parts of a partitioned backbone area through a non-backbone area
D. to enable route leaking from Level 2 into Level 1
E. to enable route leaking from Level 1 into Level 2
F. to enable OSPF traffic engineering
Answer: A,C
Cisco 642-883자료 642-883
NO.10 Which three statements are true regarding the OSPF router ID? (Choose three.)
A. The OSPF routing process chooses a router ID for itself when it starts up.
B. The router-id command is the preferred procedure to set the router ID.
C. If a loopback interface is configured, its address will always be preferred as the router ID over any
other methods.
D. After the router ID is set, it does not change, even if the interface that the router is using for the router
ID goes down. The router ID changes only if the router reloads or if the OSPF routing process restarts.
E. In OSPF version 3, the OSPF router ID uses a 128-bit number.
Answer: A,B,D
Cisco 642-883 642-883덤프
ITexamdump의 EN0-001덤프의 VCE테스트프로그램과 C_HANAIMP_1덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 LOT-410시험에 대비한 고품질 덤프와 700-303시험 최신버전덤프를 제공해드립니다. 최고품질 HP2-B104시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기